Why Is My Netgear WiFi Range Extender Blinking Red?

Why Is My Netgear WiFi Range Extender Blinking Red?

April 21, 2021 0 By Rahul Pandey

Are you confused why your Netgear WiFi range extender is blinking red? If the answer to the question is yes, then know that we have the solution to put an end to your confusion. Through this article, we’ll provide you with the troubleshooting tips that’ll help you in getting rid of the red light issue in a jiffy. But, before we do that, let’s first make you aware of the reasons why you’re facing the issue in the first place. So, without wasting any more time, let’s get down to it.

Top 5 Reasons Leading to the Red LED Light Issue

Here are the top 5 contributing factors leading to the red LED light issue:

  • The extender and router are not connected

  • You have performed Netgear extender setup partially

  • Your WiFi device is placed in a no network service zone

  • The WiFi router is not connected to the internet

  • The firmware of your extender isn’t up-to-date

Now that you know why your extender is blinking red, it’s time to proceed further and know how to troubleshoot the issue. So, here we go!

Here’s How to Resolve the Netgear Extender Red Light Issue

  • Correct Location

Make sure that your Netgear extender as well as the router are placed in close proximity. The extender is supposed to be placed in the center most location of your house. Additionally, maintain a safe between your WiFi extender and devices like baby monitors, cordless phones, treadmills, washing machines, microwaves, and much more.

  • Finger-Tight Cable Connection

Check all the cable connections. If any of them are damaged, then don’t hesitate before finding a replacement. The reason being, worn-out and damaged cables do more bad than good. Also, use a cable instead of a wireless source to create a connection between both your devices. This is because, a wireless source isn’t that reliable as compared to an Ethernet cable.

  • Carefully Perform Netgear Extender Setup

Most of the users face the red light issue because of an impartial extender setup. There is a high possibility that you might be too. Thus, ensure that you set up your extender with your eyes and ears open. Also, know that there isn’t any hard and fast rule that you need to use a particular method to set up your device. You can any of the following setup methods:

  • By pressing the WPS button on the extender

  • By using the Netgear Nighthawk application

  • By accessing the mywifiext administrative page

  • By using an Ethernet cable

  • Keep the Firmware Updated

If you haven’t updated the firmware of your Netgear extender, then it’s high time that you do. An outdated firmware causes issues that have no intention of coming into existence.

Here are the steps that you need to consider in order to update the firmware of your device:

  • Install an internet browser on your computer.

  • Go to the mywifiext.net administrative page.

  • Then, navigate to the Settings option.

  • Click on the Firmware Update button.

Wait for a couple of minutes for your Netgear WiFi range extender to get updated properly.

  • Reset the Netgear WiFi Extender

If none of the above-mentioned troubleshooting tips worked in your favor, then it is recommended that you factory default reset a try. But remember that restoring the Netgear extender will take it back to its default settings. So, if you are really ready to take the risk, then continue reading by all means:

  • Log into your Netgear extender.

  • Go to the Settings option.

  • Click on the Backup Settings button.

  • Now, hit Restore to Factory Default Settings.

Once you are done resetting your extender, check whether you have gotten rid of the red light issue or not. If not, then don’t hesitate before getting in touch with our team of technicians.

Spread the love