Tue. Sep 26th, 2023
Blocked Drains

Is it taking a little longer to clean your sink? Is the water in your sink or bathroom floor draining slower than usual? Or are you standing in an accumulated water pool on your bathroom floor? These are only some indicators that you have blocked drains.

While blocked drains may seem like a common occurrence for some, you should not leave your drain clogged for a long time. If you do, it may start giving off a foul smell, or it may cause other unpleasant accidents. To help you out, here are some common ways to clean your blocked drains Perth.

The Bent Wire Hanger

This method is simple, yet it’s surprisingly effective. Straighten up a regular wire coat hanger as best you can. Then, bend the end over to make a little hook. Start fishing when you’ve pushed it beyond the drain cover.

Through this, you will be able to remove all types of hair and debris from the drain. Also, remember that you should always be taking the trash out rather than shoving it in. When you’ve gotten everything out, turn on the hot water, and it should clean everything out beautifully.

Vinegar with Baking Soda

Get 1/3 cup baking soda and mix it with 1/3 cup vinegar. It will fizz fast, and you should flush it down the clogged drain as soon as possible. The fizzing movement will assist in removing the crud, hair, and filth that has accumulated in the pipe. Then, allow it to rest for at least one hour, preferably overnight. Then, fill the toilet with hot water. Alternatively, you may try to add extra dry baking soda first, followed by vinegar.

The Dry & Wet Vacuum

A wet and dry shop vacuum may help unclog drains. Initially, try vacuuming liquids. Cover the vents to prevent an uproar. Then, over the sink, create the tightest possible seal. You may be creative and reuse a new plunger head for such a purpose. When set to the maximum level, the suction must be strong enough to pull the blockage up the pipe. 

Hot Water

Start the kettle (or use the heater or microwaves if there isn’t one), then fill as much water as that will hold. Pour it down the sink in two or three intervals, letting the hot water work for several seconds between every pour. It is typically the simplest and fastest method of unclogging a drain. You may even reward yourself with a cup of tea if there’s any water left.

Caustic Soda

Before using this remedy, make sure to put on some plastic gloves and goggles. This is because Sodium Hydroxide may cause severe chemical burns. You may acquire some at the local hardware store, but always handle it with caution.

For this process, you will need 3/4 gallon cold water & 3 cups caustic soda in a mop bucket. With an antique wooden spoon, thoroughly combine all of the ingredients. It will start to boil and warm up. Flush it down the blocked drain, then flush it with heated water after 20-30 minutes. If necessary, repeat.

Cleaning the Pipe

First, put an empty bucket under the sink’s U-shaped pipe (the trap). This will gather the spilled water in the bucket. Then, use a plumber’s tools to loosen the slide nuts for both ends. You should be ready to finalize the operation by hand.

Remove the traps and turn them upside down to empty the contents into a bucket. You might also need to look inside for rubbish and the pipes that were holding it. An old toothbrush works well for removing challenging muck. Also, make sure to rinse the trap with water before reassembling it. That should suffice in most circumstances.

However, if you don’t know how to do this, you may want to hire an expert plumber for blocked drains Perth. This can make sure that the job is done correctly.

The Drain Snake

This is an essential piece of equipment that performs well. It is made from a long, flexible wire with metal twists at one end.

Salt and Baking Soda

Add ½ cup table salt and ½ cup baking soda into the clogged drain. After 10-20 mins, pour boiling liquid over it. The salt, baking soda, and boiling water will trigger a chemical reaction to dissolve some of the most harmful impediments.

Dish Detergent

If a toilet bowl is clogged, use a quarter cup of dish detergents. Then, heat some water. Dish soap will function as a lubricant, breaking off any oily residue. Then, fill it with hot water and also get ready to plunge. If a plunger isn’t working, rubber gloves could be the next most innovative idea.

Baking Soda, Vinegar, Gravity, and Pressure

If your bathroom drain is clogged, use a little baking soda/vinegar combination suggested in tip number two. After pouring it down the blocked drains, cover it with a stopper. For bathtubs, after around 45-60 minutes, fill the bathtub with water. You should then remove the plug. The pressure of 40-60 litres of water should be sufficient to dislodge the baking soda and vinegar-loosened barrier. You could also use a plumber’s snake or plunging with the water’s weight blocked drains Perth.

Conclusion

Having to deal with blocked drains can be quite troublesome. However, there are simple ways to deal with them, such as the ones mentioned above. Just take note that before attempting to use harsher chemicals, you may first want to try out the gentle ones. Finally, if none of these work, consider looking for professional plumbers for blocked drains near your area.

Leave a Reply

Your email address will not be published. Required fields are marked *